Cans broken machine of work principle cans broken machine used of is hammer hit of principle, is in high-speed big torque motor of drive Xia, host rotor of hammer turns of hit into to has capacity cavity inside, in capacity cavity inside need broken of broken material can get full of finely, first after has cut, and cut, and tore put these need broken of
Raymond Mill wiki , on tore into has almost standard of material, second again after has air Rotary of sorting system, on can put material in of debris, separation into metal and non-metallic this two species,Pop can Crusher system installed have a dust removal device and noise reduction device, in the process of using a pop can crusher, therefore, there is no noise and dust.Er, pop can Crusher before starting you need to check the tightness of all parts, such as loose should be fastened in a timely manner, and also checked belt tightness of wire already plugged in, motor bearings and mill shaft is balanced.
Thirdly, the can Crusher hammer, sieving and bearing these are wearing parts, so we often need to check the wear of these parts, check spindle crusher is flexible, there are no loose and Caton, if there should be resolved in a timely manner.Four, before starting you should also let the can crusher is idle for two minutes, racing's goal is to look forward, there are no anomalies and unusual sounds such as, as long as the smooth production work can be carried out only under specified speed. Five,
Vertical Roller Mill wiki during operation, to check the run of mill, feed-not too fast, it should be uniform, in order to prevent jams in the Crusher.And don't work for a long period of continuous, daily production to be in moderation. Six, you should carefully check the materials need to broken, there must be no debris, the purpose is to avoid some difficult materials, such as stone-crushing and, into the crushing cavity, which can damage the Crusher.
While Crusher operation cannot be away from the people in the process, and also not stood in the crushers the front of Crusher crushing, Crusher cannot be placed on maintenance tools or something like that. After seven, when the crusher is down, we need to clean up around the crusher, Crusher must be guaranteed around the cleaner. And when you are finished after production, cannot be immediately shut down, also need to be idle for two minutes, in order to allow fully lined material out of the
Quarry Crusher wiki , out of the line to stop.Pop can Crusher examine matters, and General pop can crusher is fixed, in this case the device must be installed in the balance on the ground, if the fixed outdoor, then you should choose to install a good environment, if need to change jobs frequently, then you will need to install on the top made of angle iron frame.
